Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - goducks

Pages: [1]

Support / Re: Phidgets - PC Host - Unlinked

« on: September 13, 2015, 12:39:30 PM »

Changed port to 5050, no luck. Restarted, re-defined port to 5050, still no luck. Any thoughts on how to deal with firewall issue? Thanks!

Support / Re: Phidget 1038 won't link up in probe section

« on: May 27, 2015, 11:18:24 AM »

Installed ITunes on PC, but BonJour does not show up. Searched for install, but am getting no simple hits for Win 7 64x. Any suggestions as to where I can easily download this? Will take this one step at a time per your great suggestion!

Support / Re: Phidget 1038 won't link up in probe section

« on: May 25, 2015, 09:59:15 PM »

Will check, traveling next couple of days, how do I change port, just enter new # in Phidget control panel? Hopefully, simple fix, thanks...

Support / Phidget 1038 won't link up in probe section

« on: May 23, 2015, 01:52:58 PM »

Am having problem linking Phidget based TC to roastmaster. Using windows based laptop, have connected serial port, and am able to read temps for single TC in Phidget control panel. Web service is on automatic. After entering serial number, and port in probe section of roastmaster, status shows as 'unlinked'. Have shut systems down and restarted, per another post on this site, no luck. Am unable to unblock Windows firewall to port 5001, per another post on this site, as not sure how to do it. Any ideas on what to try to have this link up? Anxious to play with new system, so any help appreciated (with detail, as I am not software engineer….). Thanks in advance!

Support / Re: Phidgets - PC Host - Unlinked

« on: May 23, 2015, 10:09:43 AM »

Newbie here, and having same problems mentioned earlier on this post. Using 4 port 1048, w/one thermocouple unit attached. Have downloaded Phidget install program w/files and am able to read temps on pc from Phidget control panel. Am unable to synch probes on ipad and unsure where to look for getting correct ver. #'s (if needed-did not see post for this as mentioned from Danny's earlier post). Also, am not experienced enough on port management to allow/create rule so windows does not block port 5001 for Phidgets webservice. Can anyone help with specifics on this?

Thanks!

Pages: [1]